Se connecter
Se connecter

ou
Créer un compte

ou
Ajouter ce produit à
  • Mon ancien matos
  • Mon matos actuel
  • Mon futur matos
ShaduzLabs pink-0
Photos
1/6

ShaduzLabs pink-0

Convertisseur Numérique de la marque ShaduzLabs

Écrire un avis ou Demander un avis

Annonces pink-0

Alerte nouvelle annonce

News

Images

Vidéos

Fiche technique

  • Fabricant : ShaduzLabs
  • Modèle : pink-0
  • Catégorie : Convertisseurs Numériques
  • Fiche créée le : 27/02/2017

Interface/convertisseur numérique/horloge DIY Ableton Link pour systèmes Eurorack basée sur une carte Raspberry PI Zero

When experimenting with the first breadboard based prototype, the hardware connected to the Zero board consisted of a simple RC filter, an NPN transistor and a couple of resistors for each of the two outputs (clock and reset), as shown in the block scheme above.
Even if the PCB was quite small, I still had some space left, and most of the Zero I/O pins where still unused, so I decided to add a small display, a switch, an encoder (with push button) and a bunch of LEDs.

The basic idea is to enable the audio output on the Zero, as explained in this nice article, and then to use Ableton Link for what it's best at: synchronizing an audio buffer :)
The clock and reset signals are in fact rendered respectively as the left and right channel, therefore the RC filters are required to filter off the 50Mhz PWM component and "isolate" the audio signal.
The NPN transistors then provide level shifting to 0-5 volts and clean up the edges of the clock and reset pulses.

The software part mainly consists of a daemon, which uses portaudio and Ableton Link to generate the clock and reset signals. All the signals to/from the shield are handled using wiringPI.

In terms of connectivity, there are several options:

  • If a WiFi network adapter is available upon startup, the device will act as an access point and will create a network named "pink-ap" (thanks, RaspAP!). Once you connect one or more devices running an Ableton Link enabled application to it, they'll immediately join the Link session. If you use a web browser, you can browse to the setup page and configure the device to act as a client and select any of the available WiFi network. The device then will always try to connect to the known WiFi networks upon startup and will eventually become an access point again only if none of the known WiFi networks is available.
  • If an USB-to-ethernet adapter is available upon startup, the device will join an available Ableton Link session on the local network (if available) or create a new one.
  • If no network adapters are available, the device can still be used as an independent and configurable clock/reset source for your eurorack modules ;)

The user interface offers the possibility to change the tempo (affecting all of the participants), the loop length and the clock multiplier. 


The source code, scripts, schematics and documentation are available on GitHub.

»

Autres catégories dans Convertisseurs audio hardware (DAC)

Autres dénominations : pink0