close
subdirectory_arrow_left subdirectory_arrow_left Consoles numériques
Matériel Consoles numériques {{currentManName}}swap_horiz DiGiCoswap_horiz Rechercher une marquekeyboard_arrow_down

DiGiCo SD9

Fiche technique

  • Fabricant : DiGiCo
  • Modèle : SD9
  • Catégorie : Console numérique
  • Fiche créée le : 10/07/2011
Afficher les caractéristiques

General

  • Faders 24 x 100mm touch-sensitive, motorised
  • Screens 1 x 15” (38cm) LCD high - resolution touch screen
  • Meters 24 x 8-segment LED bargraph
  • Input Channels 40 Mono or Stereo channels
  • Busses 16 Mono or Stereo busses + LR or LCR master
  • Solo busses 2 mono or stereo busses
  • Matrix 8 x 8 matrix (additional to busses above)
  • Control Groups 8, selectable for VCA-style, Moving fader, Mute Group
  • Graphic Eq 16 x 32-band, Gain +/- 12dB
  • Internal FX 4 Stereo FX processors
  • Local I/O 8 x mic/line I/O, 4 x AES/EBU I/O (mono)
  • MADI interface 1 75 ohm BNC connectivity
  • D-Rack interface 2 RJ45 shielded connectivity
  • MIDI interface In / Out / Through
  • VGA port DB-15 mini-female (1024 x 768 resolution)
  • USB ports (3) USB2
  • Ethernet port RJ45
  • Light connection (2) XLR3 1.2 – 12V
  • Ext Sync Word clock, AES, MADI
  • Headphone TRS unbalanced / 8-600 ohms 1/4 inch Jack
  • GPI 2. 1/4 inch Jack
  • GPO 2. 1/4 inch Jack

D-Rack

  • 32 mic/line inputs on 3 pin female XLR
  • 8 line outputs on 3 pin male XLR
  • Optional 8 line outputs on 3 pin male XLR or 4 stereo AES outputs on 3 pin male XLR
  • Interface to SD9 RJ45 shielded  connectivity
  • Optional 19” rack ears
  • Mains Operating range
  • SD9 surface   90-264V 47-63Hz auto ranging
  • D-Rack    90-264V 47-63Hz auto ranging
  • Mains Power Consumption
  • SD9 surface   208W 232VA (with twin PSU’s)
  • D-Rack    68W 108VA (with twin PSU’s)
  • Operating temperature   1 degree C to 40 degrees C Range
  • Storage temperature  -10 degrees to 60 degree C Range
  • Relative humidity range 0%-90% non-condensing

Physical

  • Weights and Dims  SD9: 36KGS. 878W 785D 262H
  • Weights and Dims  D-RACK: 7.4KGS. 412W 312D 179H

Audio Specifications

These specifications relate to both the D-Rack and SD9 local I/O

  • Analogue inputs:
    Gain     10 to 60dB
    Pad     -20dB
    Crosstalk    Less than 90dB 100Hz to 10kHz
    Input impedance   2500 ohms (no pad) 2650 ohms (with pad)
    Equivalent input noise  Typically -127dB (150 ohm source)
    Maximum input level  +9dB no pad +28dB with pad
    Analogue outputs:
    Output noise   typically less than -91dB
    Maximum level   +22dB
    Output impedance  Less than 50 ohms
  • Analogue I/O:
    Distortion (30dB gain)  100Hz typically 0.005%
    +10dB output   1kHz   typically 0.009% 10kHz typically 0.05%
    Frequency response  10Hz-20kHz +0/-1dB
  • Digital Inputs:
    Standard    AES/EBU Sample rate converters  SwitchableInput impedance   110 ohms
  • Digital outputs:
    Standard    AES/EBUSample rate converters  non (console word clock only)Output impedance  110 ohms
  • Digital I/O:
    Frequency response  10Hz-20kHz +/-0.1dB
    Distortion -1dBFS  100Hz typically 0.0002%
    1kHz   typically 0.0015%
    10kHz  typically 0.0015%
  • General:
    Clocking
    Clock sources   Internal, MADI, Word clock
    Clock output   BNC TTL level
    Clock accuracy   +/-25ppm
    Jitter     <+/- 5nS 50Hz-100kHz

Processing Channel Specifications

  • Input Channel
  • Name User-defined / Presets
  • Channel Selection Mono / Stereo
  • Input Routing Main & Alternate Input
  • Analogue Gain -20 to +60dB
  • Phase Normal / Reverse
  • Digital Trim -40 to +40dB
  • Delay <1.3 sec (coarse & fine control)
  • LPF 20 – 20kHz, 24dB / Oct
  • HPF 20 – 20kHz, 24dB / Oct
  • Insert A (pre eq/dyn) On/Off
  • Insert B (post eq/dyn) On/Off
  • Equalisation 4 band PEQ (or Dynamic up to 8 Stereo Processing Paths with Overdrive Software)
    (hi & lo bands switchable shelving or bell)
    Freq; 20 – 20kHz
    Gain; +/- 18dB
    Q: 0.1 -20 (parametric) / 0.10-0.85 (shelf)
  • Dynamic Eq on/off
    Over/under
    Band on/off
    Threshold; -60 – 0dB
    Attack; 500us – 100ms
    Release; 10ms – 10s
    Ratio; 1:1 – 50:1
  • Compressor Single (or Multiband, up to 8 Stereo Processing Paths with Overdrive Software)
    on/off
    Threshold; -60 – 0dB
    Attack; 500us – 100ms
    Release; 10ms – 10s
    Ratio; 1:1 – 50: 1
    Gain; 0 to +40dB with Autogain option
    Link; any channel / buss
    Hi crossover; 20Hz – 20kHz
    Lo crossover; 20Hz – 20kHz
  • Gate on/off
    Threshold; -60 – 0dB
    Attack; 50us – 100ms
    Hold; 2ms – 2s
    Release; 5ms – 5s
    Range; 0 - 90dB
    Key; Any source
    Key listen
    Freq/width; 20 – 20kHz
  • EQ/Dyn order EQ/Dyn or Dyn/EQ
  • Mute Channel mute / hard mute
  • Solo Solo Buss 1 / Solo Buss 2 / Both,
    Auto solo
  • Channel Safe Input, eq, dyn, aux, pan, fade/mute, inserts, buss, directs, full safe
  • Output Routing Buss, Insert A, Insert B, FX
    Direct: on/off, pre-mute / pre-fade / post-fade, level +/- 18dB
  • Fader 100mm motorised fader -∞ to +10dB

Processing Channel Specifications

  • Aux / Group / Matrix Output
  • Name User-defined / Presets
  • Phase Normal / Reverse
  • Digital Trim -20 to +60dB
  • Delay <1.3 sec (coarse & fine control)
  • LPF 20 – 20kHz, 24dB / Oct
  • HPF 20 – 20kHz, 24dB / Oct
  • Insert A (pre eq/dyn) On/Off
  • Insert B (post eq/dyn) On/Off
  • Equalisation 4 band PEQ (or Dynamic up to 8 Stereo Processing Paths with Overdrive Software)
    (hi & lo bands switchable shelving or bell)
    Freq; 20 – 20kHz
    Gain; +/- 18dB
    Q: 0.1 -20 (parametric) / 0.10-0.85 (shelf)
  • Dynamic Eq on/off
    Over/under
    Band on/off
    Threshold; -60 – 0dB
    Attack; 500us – 100ms
    Release; 10ms – 10s
    Ratio; 1:1 – 50:1
  • Compressor Single (or Multiband, up to 8 Stereo Processing Paths with Overdrive Software)
    on/off
    Threshold; -60 – 0dB
    Attack; 500us – 100ms
    Release; 10ms – 10s
    Ratio; 1:1 – 50: 1
    Gain; 0 to +40dB with Autogain option
    Link; any channel / buss
    Hi crossover; 20Hz – 20kHz
    Lo crossover; 20Hz – 20kHz/li>
  • Gate on/off
    Threshold; -60 – 0dB
    Attack; 50us – 100ms
    Hold; 2ms – 2s
    Release; 5ms – 5s
    Range; 0 - 90dB
    Key; Any source
    Key listen
    Freq/width; 20 – 20kHz
  • EQ/Dyn order EQ/Dyn or Dyn/EQ
  • Mute Channel mute / hard mute
  • Solo Solo Buss 1 / Solo Buss 2 / Both, Auto solo
  • Channel Safe trim, eq, dyn, fade/mute, inserts, outputs, full safe
  • Output Routing Outputs, Insert A, Insert B, FX
  • Fader 100mm motorised fader -∞ to + 10dB
Masquer les caractéristiques

Photos

Voir toutes les photos DiGiCo SD9

Avis utilisateurs

News

Dernières petites annonces DiGiCo SD9

Argus du DiGiCo SD9

Avertissement
Les prix indiqués dans les petites annonces des particuliers sur Audiofanzine ne sont pas nécessairement les véritables prix de vente ou d'achat.
Les annonces avec options, ou constituant un pack, ne sont pas prises en compte.
Moyenne des 7 annonces : 10841

Autres Consoles numériques DiGiCo

Autres dénominations : sd 9, sd9