This Is Not Rocket Science Edgecutter

• Fabricant : This Is Not Rocket Science
• Modèle : Edgecutter
• Catégorie : Modules d'effets pour synthés modulaires
• Fiche créée le : 04/05/2018

Module d'enveloppe ADSR 12 HP pour les systèmes de synthé Eurorack

• The GATE is the input that starts and stops the envelope
• RETRIG restarts the A/D cycle while the GATE is open
• VELOCITY is an input to scale the peak of the envelope
• TRIGGER is an illuminated button that enables you to manually start/stop the envelope
• A D S R all have knobs and input jacks for CV modulation
• Along the envelope you have output jacks that can send triggers or gates for each state of the envelope – allowing you to VERY precisely chain events in your system
• With the MODE BUTTON you can select between three modes of operation
  • One-shot mode – a short pulse goes through the entire envelope using the sustain level as an intermediate point
  • Gate mode – after you open the gate the envelope goes through attack and decay and waits for you at sustain until you lower the gate
  • Repeat mode – changes the sustain into a repeating A/D cycle
• Using the SPEED BUTTON you can select between a fast or a slow envelope. This changes everything by changing the mapping of the A/D/R parameters as a group.
  • fast envelope
  • slow envelope
• CURVATURE is the place where you can fade between exponential or logarithmic enveloping leading to different curvature or none at all. Turning your knob to the left creates a staggered attack and decay, turning the knob all the way right creates a staggered release.
• ENVELOPE OUTPUTS Both outputs send out the envelope but only the curved output passes on the results of your CURVATURE settings and has a signal indicator.